Sunday, February 17, 2008
DETAILS
Below are a couple details from my project. I have to complete the foundation section but will do in the morning... later this morning. I will also add the louver placement and size within the curved ceiling panel. I plan on making these operable from inside probably using a small lever crank and gears with bicycle chain. This will be diagramed later today (Sunday).
Subscribe to:
Post Comments (Atom)
1 comment:
Matt,
looking good. Personally, I would love to see a layer of exterior sheathing underneath the metal panel. I would also investigate a 3" panel and eleiminate the batten insulation inside the stud wall. The metal studs act like cooling finns on a heat-sink and reduce the actual insulation of your batts. Make sure your insulation is continuous from horizontal to vertical surfaces. How are you planning on detailing the reflector/shading device? Ther in particular the continuous insulation will be imortant and at the same time challenging.
Post a Comment